Furnace & Heating Repair · Richardson, TX
Furnace Repair in Richardson, TX
Same-day heating repair with a gas safety check included on every call.
☎ Call (972) 555-0168 Get a Free Quote
- Licensed & insured
- 24/7 emergency service
- $89 diagnostic — credited to your repair
No heat in Richardson? We’ll be out today.
North Texas furnaces sit idle for most of the year and then get asked to work on the first genuinely cold night. That’s when the failures show up — an igniter that won’t glow, a flame sensor coated in residue, a system that fires and then shuts down thirty seconds later.
Same-day diagnosis, $89 flat and credited to your repair, and a price agreed before any work starts. Every heating call includes a gas safety check, whether or not that’s what you called about.
Proud to Serve the Richardson Area
Furnace and heating repair across Richardson and the surrounding North Dallas area:
Gas safety — read this first
Gas furnaces are safe when they’re working correctly. A few symptoms mean stop what you’re doing:
- Smell of gas — rotten eggs or sulphur. Leave the house. Don’t flip switches, don’t use your phone indoors. Call the gas company from outside, then call us.
- Carbon monoxide alarm sounding. Everyone outside, call 911. CO is odorless — the alarm is the only warning you get, which is why every home with gas heat needs working detectors.
- Soot or scorch marks around the furnace, a persistent burning smell, or a flame that’s yellow and lazy rather than crisp and blue. Shut the system off and call. Those can indicate a cracked heat exchanger, which is a CO risk and not a repair to defer.
- Headaches, nausea or drowsiness that improve when you leave the house. Take it seriously. Get out, then get the system checked.
We don’t do DIY guidance on gas components, and neither should any other site. Igniters, gas valves, burners and heat exchangers are not homeowner territory. Filters and thermostat batteries are.
What a furnace repair visit includes
Full heating diagnosis
Ignition sequence, flame sensor, gas pressure, blower operation, safety switches and thermostat — because a furnace that won’t stay lit is usually a chain of causes, not one part.
Gas safety check on every call
Heat exchanger inspection, combustion check, and venting. Included whether or not it’s why you called.
A written price before work starts
Agreed first, then we work.
Common parts on the van
Igniters, flame sensors, thermostats and capacitors. Most heating calls finish in one visit.
Honest advice on older furnaces
If we find a cracked heat exchanger, we’ll tell you plainly that the system needs replacing rather than repairing — that’s a safety call, not a sales one, and it’s the one repair we’ll refuse to do.
Tested through a full cycle
We run the system through a complete heating cycle and confirm safe combustion before leaving.
What furnace repair costs in Richardson
| Repair | Typical range |
|---|---|
| Diagnostic fee | $89 flat — credited to your repair |
| Flame sensor clean or replace | $150 – $350 |
| Hot surface igniter | $200 – $500 |
| Thermostat replacement | $200 – $500 |
| Capacitor | $150 – $350 |
| Limit or pressure switch | $250 – $500 |
| Draft inducer motor | $450 – $900 |
| Blower motor | $450 – $900 |
| Gas valve | $500 – $1,000 |
| Control board | $500 – $1,100 |
These are ranges, not quotes. Your actual price depends on your system, the part, and what the diagnosis finds — and it is confirmed with you before any work begins.
On heat exchangers: replacing a cracked heat exchanger often costs a substantial fraction of a new furnace, and on a system past about fifteen years the math almost never works. We’ll show you what we found and recommend replacement. We don’t sell furnaces, so there’s nothing in that recommendation for us.
Why Richardson calls us for heating repair
Same-day, and 24/7 in a freeze
A house without heat below freezing is a burst-pipe risk, not just a comfort problem.
$89 flat diagnostic, credited to your repair
Same price discipline as our cooling calls.
Gas safety taken seriously
Every heating call includes a combustion and heat-exchanger check. It’s not an upsell line item.
We’ll tell you when to stop repairing
Fourth repair in two years on a twenty-year-old furnace? We’ll say what we’d do in your position.
No heat in Richardson? Let’s get it running.
Same-day heating repair, $89 flat and credited, gas safety check included.